Hi folks,
I have an issue here.
Trying to build firmware (I use LrOs-v1.5) to diferents firmwares that
we have in our community network , i had a issue with this especific
model (
https://deviwiki.com/wiki/TP-LINK_Archer_C5_v1.x),and need some
help to undestand:
wlan0-mesh ESSID: unknown
Access Point: 30:B5:C2:56:C0:99
Mode: Mesh Point Channel: unknown (unknown)
Tx-Power: 0 dBm Link Quality: unknown/70
Signal: unknown Noise: -101 dBm
Bit Rate: unknown
Encryption: none
Type: nl80211 HW Mode(s): 802.11nac
Hardware: 168C:003C 0000:0000 [Qualcomm Atheros QCA9880]
TX power offset: none
Frequency offset: none
Supports VAPs: yes PHY name: phy0
in dmesg i found:
[ 92.111537] overlayfs: upper fs does not support tmpfile.
[ 350.277932] ath10k_pci 0000:01:00.0: 10.1 wmi init: vdevs: 16
peers: 127 tid: 256
[ 350.295439] ath10k_pci 0000:01:00.0: wmi print 'P 128 V 8 T 410'
[ 350.301823] ath10k_pci 0000:01:00.0: wmi print 'msdu-desc: 1424 sw-
crypt: 0 ct-sta: 0'
[ 350.309973] ath10k_pci 0000:01:00.0: wmi print 'alloc rem: 20984
iram: 25656'
[ 350.378714] ath10k_pci 0000:01:00.0: pdev param 0 not supported by
firmware
[ 350.393665] ath10k_pci 0000:01:00.0: set-coverage-class, phyclk: 88
value: -1
[ 350.402059] IPv6: ADDRCONF(NETDEV_UP): tmp.phy0: link is not ready
[ 355.759072] ath10k_pci 0000:01:00.0: 10.1 wmi init: vdevs: 16
peers: 127 tid: 256
[ 355.776571] ath10k_pci 0000:01:00.0: wmi print 'P 128 V 8 T 410'
[ 355.782953] ath10k_pci 0000:01:00.0: wmi print 'msdu-desc: 1424 sw-
crypt: 0 ct-sta: 0'
[ 355.791140] ath10k_pci 0000:01:00.0: wmi print 'alloc rem: 20984
iram: 25656'
[ 355.859763] ath10k_pci 0000:01:00.0: pdev param 0 not supported by
firmware
[ 355.867103] ath10k_pci 0000:01:00.0: must load driver with rawmode=1
to add mesh interfaces
Anyone had this issues before?
thanks
Hiure
